V2 Guitar Amp Head

The Randall V2 Amp Head was developed for the guitarist who likes multiple tone-shaping options. The V2 amplifier head can produce almost any tone you can imagine, using a full tube preamp as well as a classic Randall solid-state preamp. Holding true to hi-gain roots, Randall pushed the boundaries of modern design that has resulted in this original take on hybrid guitar amplification.

A revolutionary new tube-driven MOSFET power section called "Valve-Dynamic" powers the V2 with so much reaction and feel that you would swear it was a full set of power tubes driving the amp. This 12AT7 driven power circuit not only has the feel, but also an accurate frequency response found only in a full tube power section.

Product Details
400W @ 4 Ohms, 280W @ 8 Ohms, 500W@2 Ohms
3-MIDI programmable channels:
Ch.3: All tube preamp with 3-12AX7 preamp tubes. Includes "Attack" switch for tight and loose feel, and "Bright" switch.
Ch. 2- Classic Randall S.S. channel with push/pull "Sustain Boost".
Ch. 1- Classic full clean with big headroom.
MIDI Assignable 6-band Graphic EQ with single On/Off switch. Can be activated for any/all channels then stored and recalled by the included 5-button MIDI foot controller.
Assignable "Series" or "Parallel" Effects loop with single On/Off switch. Can also be activated for any/all channels then stored and recalled by the included MIDI foot controller.
Master front "Volume" control
Master "Density" control. Adjusts the power amp low end dynamics.
Master "Presence" control. Adjusts the power amp extreme high end dynamics
MIDI in/thru
Mic Eliminator XLR direct recording output
World voltage AC inlet