Features

• Buffered gold-contact inputs for unbalanced instruments such as guitars and basses
• Reverses signal polarity at the corresponding amplifier output to help correct phase issues when using multiple amps simultaneously
• The front panel jacks take priority over the rear panel instrument inputs
• Large switches with green LED indicators turn each instrument input on/off
• Multiple inputs can be on simultaneously
• Standard 5-pin MIDI connector allows MIDI controllers to activate the inputs and outputs of the JX44 V2
• Eight dip switches con gure channel, program, and control changes
• Can be used in conjunction with the JR-5 remote
• Selects whether the left or right EFX loop inputs feed the corresponding amplifier output
• When ‘dry’ is selected, the EFX Loop will not feed the amp output
• Disconnects the shield on the corresponding amplifier output to eliminate hum and buzz caused by ground loops
• Switch with red LED indicator cuts all outputs except for the Tuner out
• Buffered unbalanced output to feed a tuner pedal-this output is fed by all inactive instrument inputs, and will always be active even if the Mute switch is engaged
• Buffered and Jensen-transformer isolated gold-contact outputs for feeding up to four stage amplifiers
• Balanced XLRM output to feed a mixer or recording interface
• Lift switch disconnects pin-1 to eliminate hum and buzz
• Assign switch selects whether the Direct Out is fed a pre or post EFX signal, or instrument input 4 exclusively
• Connections for unbalanced instruments, wired in parallel with front panel connections
• Connection for standard IEC power cable. 120V/240V operation for international use
• XLRM allows connection to the optional JR-5 remote for footswitch control of either the instrument inputs or the amplifier outputs
• Two JR-5 remotes can be used simultaneously
• 1/4” TS jack for connection to standard momentary footswitches such as the JR1-M to turn on/off the EFX Loop remotely
• 1/4” TS send and receive connections for local effects pedal chains
• Balanced SGI loop works with the optional SGI-44 to drive long cable runs to and from a remote pedalboard

Get full control over even the most complex touring rigs. Order today.