AMT ACC3 Mono Accordion Microphone System

The ACC3 is a multi condenser 3 microphone system for smaller accordions. The mic system contains the latest components in micro electronics. The ultra low mass makes placement easier than ever. The system comes with the "Nano Blend" belt pack.

Housing most of the electronics outside of the accordion makes installation less complicated. With fewer holes to drill, it is easier and more dependable over many years of use. The battery is changeable outside of the accordion because it is located in the belt pack. It's small size and low mass gives the end user the ability to permanently or temporarily mount the microphone without major modifications to the accordion.

The ACC3 accordion microphone comes with a wiring harness allowing installation of the bass mic through the bellows and mounted close to the bass machine. Some modification may be necessary to accommodate the third microphone.

The system is best suited for mic level inputs (PA systems) but also works with line level amps. The ACC3 will be wireless capable, able to be interfaced with major brand wireless products. The 9 volt battery life for operation is between 80-120 hours of intermittent use before replacement. The output of this system is activated by the quarter inch jack output when plugged in.

The ACC3 Mono version has mixing capabilities right on the belt pack. The belt pack has two gain controls to adjust the volume of the right hand microphones in relation to the left hand microphones. Both hands terminate to a 1/4 inch standard patch cable. The belt pack also has trim filters. The trim filters only cut the highs / and or lows for both the right and left hand independently. You cannot boost highs or lows, this feature is designed to help the players with feedback in certain rooms.

Use it with piano accordions, button accordions, chromatic accordions, free bass accordions 12 bass ” 120 bass accordions, and Cajun accordions. System includes three AMT ACC3 Microphones Nano Blend Belt Pack Preamp, 1 Output connector Jack with nut. Mounts to grill, 1 Coil Cable to extend Left hand microphone through bellows, 2 L Shaped Brackets mounts inside the bellows, 1 Disconnecting circuit board that junctions all wires together, 1 1/8 inch cable (Connects accordion to the belt pack), wood screws (Used only if needed for securing microphones and/or L brackets.

Requires phantom power.