ULXP14D Dual Guitar/Bass Wireless System

ULXP14D Dual Guitar/Bass Wireless System Specifications:

• RF Carrier Frequency Range: 554.000 to 865.000 MHz (Available frequencies depend on the applicable regulations in the country where the system is
• used). Refer to the frequency supplement supplied with the system.
• Effective Range: 100 m (300 ft.) under optimal conditions (NOTE: Actual working range depends on RF signal absorption, reflection, and interference)
• Audio Frequency Response: 25 to 15,000 Hz, ± 2dB (NOTE: Overall system frequency response depends on the microphone element.)
• ULXP4 Receiver Input
• Connector: Antenna Power Input
• Connector Type: BNC IEC 320
• Actual Impedance: 50 Ohms
• Nominal Input Level: ”95 to ”30 dBm 15 VDC
• Maximum Input Level: +6 dBm (”20 dBm recommended) 18 Vdc
• Pin Assignments: Shell = Ground Center = Signal IEC Standard
• Voltage for Remote Power: 12 Vdc, 150 mA maximum
• ULXP4 Receiver Output
• Connector: High Z Audio; Low Z Audio
• Output Configuration: High Z Audio Unbalanced (1/4 in.); Low Z Audio Balanced (XLR)
• Actual Impedance: High Z Audio 3 k0hms; Low Z Audio 22
• Nominal Input Level: High Z Audio Pin Assignments: Tip = Hot Ring/ Sleeve = Gnd: Low Z Audio 1 = Ground 2 = Hot 3 = Cold
• Voltage/Current/Phantom: Power Protection?: High Z Audio; Yes Low Z Audio Yes
• ULX1 Transmitter Input
• Connector: TA4F
• Input Configuration: Unbalanced, active
• Actual Impedance: 18 kohms with lavalier microphone; 1 Mohms with instrument cable
• Maximum Input Level: 10 Vp”p (12 dBV) for 1% THD at minimum gain setting
• using 1 kHz signal.
• TA4F Connector Pin Assignments: Pin 1: Tied to Ground; Pin 2: Tied to +5 V; Pin 3: Tied to Audio; Pin 4: Tied thru 20kohms Resistor to Ground. (On instrument adapter cable, Pin 4 floats)
• Voltage for Remote Power: +5 V supplied to microphone cartridge
• ULX1 Transmitter Output
• Actual Impedance: 50 Ohms
• Nominal Output Level: 20 mW
• Maximum Output Level: 30 mW
• Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive
• voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output
• Transmitter Gain Adjustment Range: ULX1: 25 dB
• Receiver Audio Output Level (± 38 kHz deviation, 1 kHz tone):
• XLR connector (into 600 ohm load): +3.9 dBV (line), ”17 dBV (mic)
• 1/4 inch connector (into 3000 ohm load): ”2 dBV
• Impedance: ULX2 (input): 1 Megohm; ULXP4 (output): 50 ohms at line level; 2000 ohms at mic level
• Modulation: ±38 kHz deviation compressor-expander system with pre- and de-emphasis.
• RF Power Output: ULX2: 30 mW maximum
• Dynamic Range: >100 dB, A-weighted
• RF Sensitivity: 1.26 uV for 12 dB SINAD (typical)
• Image Rejection: 80 dB typical
• Spurious Rejection: 75 dB typical
• Ultimate Quieting (reference ± 38 kHz deviation): >105 dB, A-weighted
• System Distortion (reference ± 38 kHz deviation, 1 kHz modulation): 0.3% total harmonic distortion, typical
• Power Requirements: ULX2: 9V alkaline battery; 8.4 V Nicad optional; ULXS4: 14 - 18 Vdc (negative ground), 550 mA
• Battery Life: 8 to 9 hours (with 9V alkaline battery)
• Operating Temperature Range: - 20 degrees to 49 degrees C (- 4 degrees to 120 degrees F)
• NOTE: Battery characteristics may limit this range
• NOTE: Bodypack and Handheld Transmitters cannot be used simultaneously
• ULXP4 Dimensions (H x W x D): 1.72 in. x 8.56 in. x 6.88 in. (43 mm x 214 mm x 172 mm)
• ULXP4 Weight: 2 lbs 7 oz. (1105 g)
• ULX1 Dimensions (H x W x D): 3.86 x 2.68 x 1.10 in. (96.5 x 67 x 26.7 mm)
• ULX1 Net Weight: 79 g (2.8 oz.) without battery